Kastar 113 High Modulus PU Sealant for Construction

• Customization: Available
• Bonding Function: Structural Adhesive
• Morphology: Solid-State
• Model NO.: 113
• Application: Construction
• Material: Silicone
• Classification: Room Curing
• Main Agent Composition: Rubber
• Characteristic: Waterproof
• Composition: Organic Material
• Color: Clear
• Transport Package: Box

Product Description

KASTAR113 Construction Joint Polyurethane sealant is a multifunction gun-grade polyurethane-based construction sealant, it is of high modulus and cures by reaction with atmospheric moisture to form a soft rubber-like material with moderate elasticity and high adhesion strength.

Technology datasheet

Testing Items	Performance
Appearance	Black/White/Gray homogeneous paste
Density (g/cm³)	1.35±0.05
Sagging properties (mm)	0
Elongation at break (%)	≥600
Volatile content (%)	≤4
Stretch modulus (Mpa)	>0.4
Touch dry time (min)	≤180
Elastic recovery rate (%)	≥85
Extrudability (ml/min)	≥80
Pollution properties	Non
Application temperature (ºC)	+5~+35
Shelf life(month)	9

Note:

1. All data above were tested under standardized conditions.
2. All data listed in the chart were for the generalized item in the series; please refer to the related datasheet for special items.
3. Storage condition has a direct impact on the product's shelf life, Please refer to the instruction for special items' storing.

Advantage

• Mildew proofing, Meeting national standards for sealing drinking water pipes.
• One component, no need of mixing.
• Easy for applying.
• Excellent elasticity and adhesion strength.
• Excellent durability, and weathering resistance..
• Self-bonding, easy for repairing.
• Three kinds of colors are available.

Uses

• Suitable for joints where high resistance to penetration and pressure is required.
• For joints where low movement capacity is required.
• Joints in paving, airport, and bridge runway.
• Seams on water pipe(back to water).

Cleaning

Clean and dry all surfaces by removing foreign matter and contaminants such as oil dust, grease, frost, water, dirt, old sealants, and any protective coating. Dust and lose particles should be cleaned.

Package

310ml cartridge, 20 pcs/inner carton; 2 inner boxes/outer box
600ml/400ml sausage, 20 pcs/carton; 2 inner boxes/outer box

Application

Minimum application temperature: 5ºC.

KASTAR113 should be dispensed from either the cartridge or sausage by means of a caulking gun. Pierce the membrane at the top of the cartridge and screw on the nozzle. Cut the nozzle to give the required angle and bead size. Place the cartridge in an applicator gun and squeeze the trigger. For sausages, a barrel gun is required, clip the end of the sausage and place it in the barrel gun. Screw the end cap and nozzle onto the barrel gun. Using the trigger extrude the sealant, to stop depression using the catch plate. Apply KASTAR113 in a continuous bead using enough pressure to properly fill the gaps.

Advice

• For common occasions, after cleaning out the surface with the organic solvent, this product can be used directly.
• Please construct by application instructions strictly, failure of stickiness may be caused by any operation disobeying construction techniques.
• This product is innocuous after curing completely, but before set, please avoid contact with eyes and skin. In case of eye and skin contact, wash immediately and thoroughly with soap and water. See a doctor immediately if it is serious.